Zhone ENE2084 Spécifications

1ENE2044 and ENE2084E1 Network Extenders Installation InstructionsDocument Number ENE2-A2-GN11-10March 2005ContentsSoftware and Firmware License Agree

10Web InterfaceThe network extender’s integral Network Management System (NMS) lets you configure and monitor the network extender using a standard we

115. Write down the current IP Address and Subnet Mask in the Internet Protocol (TCP/IP) Properties dialog box. When you are done using NMS, you will

12From this screen you can: Establishing an ARP Table Entry for a Subscriber UnitInband management is turned on by default in the subscriber uni

13For security purposes you may want to turn off inband management of the unit to prevent a local PC from managing the unit from the Ethernet ports.Co

14Launching the Terminal Emulation ProgramLaunch the terminal emulation program on your PC and configure the program settings. Actual configurations w

15Pin AssignmentsE1 RJ45 Pin AssignmentsIf you are using a shielded E1 cable for your network connection, it must be grounded through pins 3, 6, 7 and

16DB9 to RJ45 Adapter PinoutsTo connect the COM port to the DB9 serial port of a PC, use an adapter wired as shown: Pins not shown are unused.Table 5

17SpecificationsSpecifications are subject to change without notice.Table 6. SpecificationsSpecification CriteriaDimensions 1.25" (3.2 cm) High x

18EMI NoticesUnited States – EMI Notice:This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to P

19Important Safety Instructions1. Read and follow all warning notices and instructions marked on the product or included in the manual.2. Do not allow

2The terms and conditions of this License Agreement (the “Agreement”) will apply to the software and/or firmware (individually or collectively the “So

20Product Documentation OnlineComplete documentation for Paradyne products is available at www.paradyne.com. Select Support → Technical Manuals.To ord

37. The rights granted under this Agreement may not be assigned, sublicensed or otherwise transferred by the Licensee to any third party without the p

4Package ContentsUnpack and Inspect the network extender. If there is any visible damage, do not attempt to connect the device. Contact your sales or

55. Verify that the Power LED on the front of the network extender is illuminated.04-1760410/100 Ethernet ConnectionsLnk/ActENE2044Duplex/Collision100

6Connecting the E1 LinesThe primary feature of the network extender is loop bonding capability, although both the provider and subscriber units are ab

7Single E1 ConnectionA single line connection can be established between a subscriber unit and any Paradyne E1 provider unit, regardless of loop bondi

8LED IndicatorsTable 2. LEDs (1 of 2)LED State Indication Additional Information10/100 Ethernet Connections Lnk/ActPulsing GreenStandard operation Tra

9E1 Connections Lnk/Alm (Ports 1–4 or 1–8)Flashing Green*E1 connection is established and activeTraffic is flowing.Solid GreenE1 link A connection exi