Zhone Hotwire 5446 Spécifications

1Hotwire 5030 POTS Splitter Customer PremisesInstallation InstructionsDocument Number 5030-A2-GN10-20December 1999What Does the Hotwire 5030 POTS Sp

10Hotwire 5030 POTS Splitter Technical SpecificationsItem Specification*Height x Width x Depth 6.65″ x 5.44″ x 2.25″ (16.89 cm x 13.82 cm x 5.72 cm)W

11!Important Safety Instructions1. Read and follow all warning notices and instructions marked on the product orincluded in the manual.2. This produc

12If the Model 5030 Telephone Line Filter causes harm to the telephone network, thetelephone company will notify you in advance that temporary discon

2PreparationVerify that:-The local loop POTS is connected to the POTS/DSL network at the punchdownblock or NID.-New or existing unshielded twisted-pa

97-15247POTS Splitter Housing 3Mounting the POTS Splitter HousingThe POTS splitter can be placed:H On the outside of the building near the punchdown b

97-15437-01LeverClosureScrew 4Preparing the POTS Splitter" Procedure1. Unscrew the closure screw and open the housing by pressing on the lever on

5Installing the POTS Splitter WiringThe local loop terminates at the punchdown block or NID. Wiring must be connectedfrom the customer premises side

6Green and Red are the standard pair wiring colors used in the next example for TipT1 and Ring R1. Your wiring may differ.DSL/POTSFrom LocalLoopTelep

7Reconnecting to the Local Loop" Procedure1. Feed new jumper wiring through the POTS splitter rubber grommet. Remove theinsulation at the end of

97-15251LeverClosureScrew 83. Locate the T1/R1 connectors on the customer premises side of the punchdownblock or NID where the existing POTS wiring wa

9DSL Access Wiring" Procedure1. Attach new wiring to the T1/R1 connectors that will go to the DSL jack from thepunchdown block or NID.2. Tighten