Zhone 6210 Guide de l'utilisateur télécharger pdf (Page 40)

Hotwire 6210, 6211, and 6381 User’s Guide

4.7.1 System Commands

To make changes permanent, click on Tools (at the top of the page) and select System Commands. The following

commands are used to configure the CPE:

• Save all: Press this button in order to permanently save the current configuration of the modem. If you do restart

the system without saving your configuration, the CPE will revert back to the previously saved configuration.

• Restart: Use this button to restart the system. If you have not saved your configurations, the modem will revert to

the previously saved configuration upon restarting. Connectivity to the unit will be lost. You can reconnect after

the unit reboots.

• Restore Defaults: Use this button to restore factory default configuration. Connectivity to the unit will be lost.

You can reconnect after the unit reboots.

4.7.2 Remote Log

The remote log feature is used in conjunction with the PC tool (software provided with your modem). For PPPoE and

PPPoA connections, you can select debug if you want to log the connection information. This is helpful when trying

to debug connection problems.

The remote log feature forwards all logged information to the remote PC. The type of information forwarded to the

remote PC depends upon the log level. Each log message is assigned a severity level, which indicates how seriously

the triggering event affects router functions. When you configure logging, you must specify a severity level for each

facility. Messages that belong to the facility and are rated at that level or higher are logged to the destination

Table 4-1 defines the different severity levels.

Table 4-1. Severity Level

To forward logging information, click on Tools (at the top of the page) and select Remote Log.

4.7.3 User Management

To change your modem’s username and password:

1. From the Home screen, under the tools menu, click on User Management.

2. Change the login name and password.

3. If desired, you can change the idle timeout from this screen. The idle timeout determines after how many minutes

of inactivity the web interface is logged off.

The Apply button will temporarily save these settings. To make the change permanent, click on Tools (at the top of

the page) and select System Commands. At the System Commands page, click on Save All.

If you forget your password, you can press and hold the reset to factory defaults button for 10 seconds. The modem

will be reset to its factory default configuration and all custom configurations will be lost.

40 April 2004 6210-A2-GB21-10

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 46

Pas de commentaire

Zhone 6210 Guide de l'utilisateur Page 40