Zhone TNE1544 Spécifications télécharger pdf (Page 10)

Web Interface

The network extender’s integral Network Management System (NMS) lets you configure

and monitor the network extender using a standard web browser.

To manage a Provider unit using NMS, connect your PC to any Ethernet port of the

Provider unit.

By default, the Subscriber unit can be managed by the NMS through its T1 and Ethernet

ports, but you must first create a static entry for the unit in your PC’s ARP table.

Establishing an ARP Table Entry for a Subscriber Unit

The subscriber unit will not respond to an ARP request containing the unit’s default IP

address. In order to manage the subscriber unit using NMS you must create a static

ARP table entry on your PC. To build a static ARP table entry:

Procedure

1. Get the MAC address from the bottom label of the subscriber unit.

2. Open a command prompt. (Click on Start, then Run. In the Open: window type

CMD and press Enter.) At the command line, type:

arp -s 192.168.254.251 xx-xx-xx-xx-xx-xx

where the IP address is the default address of the subscriber unit and the MAC

address is the number on the bottom label with 1 added to the last byte. For

example: if the MAC address on the bottom label is 00-50-ca-01-28-86, use

00-50-ca-01-28-87 in the arp command. If the MAC address on the label is

00-50-ca-01-28-ea, use 00-50-ca-01-28-eb in the arp command.

Once the ARP table entry is configured, you can manage the unit using NMS.

If you change the IP address to anything other than the default, the subscriber unit

responds to ARP requests and does not require a static ARP table entry to manage it

using NMS.

For security purposes you may want to turn off inband management of the unit to

prevent a local PC from managing the unit from the Ethernet ports.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

Pas de commentaire

Zhone TNE1544 Spécifications Page 10