Zhone 6210 Guide de l'utilisateur télécharger pdf (Page 52)

3. Using the Web Interface

3-24 January 2005 6210-A2-GB23-00

Figure 3-18. LAN Isolation

Bridge Filters

The bridge filtering mechanism provides a way for the users to define rules to

allow or deny frames through the bridge based on source MAC address,

destination MAC address and/or frame type. When bridge filtering is enabled,

each frame is examined against the defined filter rules sequentially, and when a

matched is determined, the appropriate filtering action (allow or deny) is

performed. The bridge filter will only examine frames from interfaces which are

part of the bridge itself. Twenty filter rules are supported with bridge filtering.

To enable Bridge Filters:

Procedure

1. From the Home screen, click on Advanced.

2. Under Advanced, select Bridge Filters. The Bridge Filters screen appears, as

shown in Figure 3-19, Bridge Filters.

The User Interface for Bridge Filter allows the user to add, edit, and delete, as well

as enable the filter rules. To add rules, define the source MAC address, destination

MAC address, and frame type with the desired filtering action (allow or deny), and

click on the Add button. The MAC address must be in a xx-xx-xx-xx-xx-xx format,

with 00-00-00-00-00-00 or blanks meaning any address.

To edit or modify an existing filter rule, select the desired rule created previously in

the Edit select box. The selected filter rule appears in the top section, as with the

Add procedure. Make the desired change to the MAC address, frame type and

access type, and click on Apply.

To delete a filter rules, select the filter rule entry to delete in the Delete selection

box. Note that multiple deletions are possible. Once all the desired filter rules are

selected for deletion, click on the Apply button. The Select All select box can also

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 71 72

Pas de commentaire

Zhone 6210 Guide de l'utilisateur Page 52