Zhone 6210 Guide de l'utilisateur télécharger pdf (Page 54)

3. Using the Web Interface

3-26 January 2005 6210-A2-GB23-00

3. Click in the check box to enable the IGMP proxy. Select the WAN connection

that IGMP messages should be sent to.

4. The Apply button will temporarily save these settings. To make the change

permanent, click on Tools and select System Commands. On the System

Commands page, click on Save All.

Figure 3-20. Multicast

Static Routing (6211 Only)

If the modem is connected to more than one network, you may need to set up a

static route between the networks. A static route is a predefined pathway that

network information must travel to reach a specific host or network. You can use

static routing to allow different IP domain users to access the Internet through the

modem.

To enable Static Routing:

Procedure

1. From the Home screen, click on Advanced.

2. Under Advanced, select Static Routing.

3. Specify the New Destination IP. This is the address of the remote LAN network

or host to which you want to assign a static route. Enter the IP address of the

host for which you wish to create a static route here. For a standard Class C IP

domain, the network address is the first three fields of the New Destination IP,

while the last field should be 0. The Subnet Mask identifies which portion of an

IP address is the network portion, and which portion is the host portion. For a

full Class C Subnet, the Subnet Mask is 255.255.255.0.

4. Specify the Gateway address. This is the IP address of the device that allows

contact between the modem and the remote network or host.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 71 72

Pas de commentaire

Zhone 6210 Guide de l'utilisateur Page 54